The Brown/white and black/yellow (gnd) wire pair are for the "city light" circuit on European models. .
If this doesn't leave enough padding, the dip can be removed by being built up, and the dish can be made flat. .
Stainless steel wool can be used instead of fiberglass. .This is a fairly standard thread size for countershafts. .The KLR bodywork is made out of polypropylene (a.k.a.Can I get the stock grips off in one piece?See the links section for a way to report balancer failures.If your Kawi dealer doesn't have the right ones in stock, shims from an '87 BMW K75S and '82 Yamaha Seca 750 are the same diameter. .However, these changes are usually small, and can also be cured with jetting. .Are there any alternatives to Kawi valve shims?2017 Motorcycle ATV Technical Data Labor Guide Online.Any larger cover should work. .
Off road, feelings are mixed.
(Both units are of equal quality, although they offer different spring lengths.) In addition, the adjuster bolt and spring were upgraded in 1996; earlier models can be upgraded by replacing the bolt and spring, and adding the washer. .
Also remember to remove the retaining rings before taking the old ones out.
note: The KLR comes with both right- and left-hand keys (the direction of the offset in the cross-section). .You can rotate the shift lever up one notch on the spline, or try an IMS abbyy finereader 7 pro shift lever, which is longer than stock.The standard KLR sizes are 90/90-21 front and 130/80-17 rear. .Why is my battery running out of water?Shift lever breakage Many riders have seen the stock shift lever break at the base weld. .KLRs have made a few appearances on the small and big screens: There is a furry KLR in the last deleted scene on the Haiku Tunnel DVD One of the bikes near the end of The Fast And The Furious is suspected to.(Or, if you bottom the nut and the wheel still isn't tight.) Poor speedometer accuracy The KLR speedo generally reads about 10 higher than true speed. .